Pro AV Catalog
West Penn Wire - AV-IP-AMPRX
Request Quote
All Products

2-channel Audio AMP IP Receiver Unit

Model: AV-IP-AMPRX

  • Supports dual 2CH Audio inputs and a Mic input (TX)
  • Extend 2CH Audio or Mic signals up to 330ft (100m) over Cat5e/6 cable
  • Supports a 2x50W Amplifier, and bridge-mode for 1x100W (RX)
  • Supports Digital Audio Out (RX)
  • Control input selection, volume, bass and treble (TX)
Compare
Project List
Product Info
Tech Specs
Documents

The Audio AMP IP Receiver allows 2CH audio signals to be extended up to 330ft (100m) via one (1) Cat5e/6 UTP cable in a point-to-point configuration. Point-to-multipoint and multipoint-to-multipoint is possible by connecting several Transmitters or Receivers to the same local Ethernet network. These units support RS232 and IR transmission for remote control of end devices. IR emitters and sensors are not included, but may be purchased separately if required.

For the point-to-multipoint and multipoint-to-multipoint configuration the Ethernet Switch must have Gigabit ports and DHCP Server capability and additionally support the IGMP communication protocol for the multipoint-to-multipoint case. West Penn Wire recommends using the Cisco SG300 or SG500X Series Managed Switches. The West Penn Wire IP Device Controller (AV-IP-NC811) is available to simplify the configuration and utilization of the AV-IP-AMP and other West Penn Wire IP based products via an Ethernet web interface.

  • Supports dual 2CH Audio inputs and a Mic input (TX)
  • Extend 2CH Audio or Mic signals up to 330ft (100m) over Cat5e/6 cable
  • Supports a 2x50W Amplifier, and bridge-mode for 1x100W (RX)
  • Supports Digital Audio Out (RX)
  • Control input selection, volume, bass and treble (TX)
  • Manage TX unit locally via push/turn dial or remotely via AV-IP-NC811 web interface
  • Supports point-to-point, point-to-multipoint and multipointto-multipoint applications
  • Supports 100’s of Transceivers depending on network bandwidth
  • Supports RS232 and IR transmission for remote control of end devices
  • Transmitter may be PoE powered
  • Applications:
  • Commercial and residential AV systems
  • K6 and K12 classroom AV systems
  • Digital signage
  • Boardroom systems
  • Collaborative PC systems
  • Medical information systems
 
Request Quote
 

Suggested Products