The CSM4 quad conductor cable is designed from the inside out to be the finest studio and stage grade cable available.  Every component of the cable itself is carefully chosen with the end goal of creating a tough, flexible, and dead-quiet microphone cable.  It’s not an ordinary cable. Here’s a closer look:

Inner Conductors:

There are four cores that are very tightly twisted with a very short lay length. Each core is constructed of 26 strands of .1 pure bare copper.  These conductors are transparent, precise, and extremely flexible.  The high twist rate of these four conductors around each other results in dramatically improved rejection of electromagnetic interference when compared to standard two?conductor mic cables.  In some cases, the noise reduction could be up to 20db.

Inner Conductor Insulators:

The insulator that was chosen to separate the four inner conductor cores is cross linked polyethylene, or XLPE  .  This insulator is a thermosetting compound made from a polymer resin that has been irreversibly cured to form a special type of insulator that is less prone to shrinking when heated.  We chose XLPE over the less expensive old-fashioned PVC because it has much lower dielectric loss and, despite its smaller diameter, is easier to solder without shrinkage.  PVC certainly would have been cheaper.  We weren’t trying to build the world’s cheapest cable, we set out to build the best.   With careful attention to our selection of soldering equipment and the temperature and methods used to solder, the XLPE was the obvious choice for our quad conductor CSM4.  We selected two blue and two white for the four insulators.