The ZC-FIRE is a dedicated fire safety interface provides either output muting or programmable scene selection upon being triggered by either a relay or control voltage from the fire safety system for the dbx ZonePRO devices. Connection to the fire safety system shall be either through a relay or directly to the control voltage output. The remote device shall have DIP switches allowing identification with connection to the processing device via CAT5 cable on RJ-45 connectors. The device shall be a dbx ZC-FIRE remote controller. The zone controller offer extended utility to the DriveRack and ZonePRO families. The zone controllers use analog DC voltage to provide logic control ranging from zone source selection, volume and muting, to program or scene selection and fire safety muting. Wired with readily available and affordable CAT5 cable with universally accepted RJ-45 connectors at distances up to 1000ft. The ZC zone controllers offer simple yet elegant solutions to the contractor.
Provides either output muting or programmable scene selection ZonePRO devises
Offers extended utility to the DriveRack and ZonePRO families
Offers simple yet elegant solutions
Maximum cable length varies with number of zone controllers
Use analog DC voltage to provide logic control ranging from zone source selection, volume and muting
Wired with CAT5 cable with universally accepted RJ-45 connectors at distances up to 1000ft
UL 60065, IEC 60065, EN 55013 and E60065 safety agency certifications
Spec Sheet available - Yes
Connectors:
(2) RJ-45, (2) 2-pin Phoenix
Series Wiring:
Maximum cable length varies with number of zone controllers (600ft for 3 zone controllers 300ft for 6 zone controllers)
Parallel Wiring using ZC-BOB:
Up to 6 zone controllers (1000ft)
Parallel Wiring Cable:
CAT5 or CAT5E with 28.6 Ohms/m (Ohm/1000ft) nominal DCR and rated VW-1 or higher
